1Zpresso / 1zpresso-zp6
ZP6
A practical reference for the ZP6's external adjustment ring, sold in English material as the ZP6 Special. Begin inside the suggested range, then adjust one or two clicks at a time for the coffee, recipe, and taste in front of you.
number range chart
First-party starting ranges from 1Zpresso's ZP6 Special reference chart, read off the nine printed numbers. Ten clicks sit between one number and the next, so 4.5 means number 4 plus five clicks. These are guides, not fixed recipes.
pour-over / filter
4–5 numbersAeroPress
recipe dependentThe official reference chart covers only siphon or pour-over and French press, so 1Zpresso publishes no numeric AeroPress range for this grinder.
French press
5–6 numbers
reading the ring
A setting is read where the red dot points, counted from the position where the burrs first resist the handle.
- 01
Empty the grinder so no beans sit between the burrs.
- 02
Turn the ring anti-clockwise until you feel resistance and the handle begins to turn against it; that position is zero.
- 03
Turn clockwise and read the number the red dot reaches, then count single clicks past it for the decimal.
One click is 22 microns and ten clicks make one printed number, so a whole number is a large move and a click is a small one. Start near the middle of a recommended range. Move finer if the cup is weak, sharp, or fast; move coarser if it is harsh, dry, or slow. Taste remains the final calibration.
1Zpresso / 1zpresso-zp6
ZP6
一份针对 ZP6 外置调节环的实用参考；英文资料中这台研磨器以 ZP6 Special 的名称销售。先从建议范围内开始，再根据眼前的咖啡、配方和口味，每次微调一至两格。
刻度范围图
来自 1Zpresso ZP6 Special 官方刻度建议表的起始范围，按调节环上的九个数字读取。相邻两个数字之间有 10 格，因此 4.5 表示数字 4 再加 5 格。这些是调试指南，并非固定配方。
手冲 / 滤泡
4–5 刻度爱乐压
取决于配方官方刻度建议表只标注虹吸／手冲与法压壶，因此 1Zpresso 没有为这台研磨器公布爱乐压的数字范围。
法压壶
5–6 刻度
读懂调节环
刻度以红点所指的位置读取，并从刀盘刚开始对摇臂产生阻力的位置计起。
- 01
清空研磨器，确保刀盘之间没有咖啡豆。
- 02
逆时针转动调节环，直到感到阻力、摇臂开始带着阻力转动，该位置即为零点。
- 03
顺时针旋转，读出红点指到的数字，再逐格计数得到小数部分。
一格是 22 微米，十格构成一个数字，因此整数是大幅调整，单格则很细微。先从建议范围的中间开始：淡薄、尖锐或流速过快就调细，苦涩、干燥或流速过慢就调粗。最终仍以味觉为准。